Allied-telesis AT-2972T/2 Manual de usuario descargar pdf (Pagina 122)

Troubleshooting

122

Solution: When the system is booted up without an adapter, the bus

operates at the lowest mode which is PCI. This problem can be corrected

by rebooting the system.

Problem: The adapter may not perform at optimal level when it is added

by the Hot Plug application on some systems.

Solution: The system BIOS, in some systems, does not set the cache line

size and the latency timer, after the adapter is added by the Hot Plug

application. This problem can be corrected by rebooting the system.

Problem: The adapter cannot be seen on the PCI BUS.

Solution: This is because some of the older servers are advertising

themselves as PCI-X capable systems. This causes the adapter to

operate in PCI-X mode; therefore; it is not seen by the PCI bus. This

problem can be corrected by configuring the firmware to operate in forced

pci mode. Refer to b57diag for configuration instructions.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 143 144

Sin comentarios

Allied-telesis AT-2972T/2 Manual de usuario Pagina 122