Allied-telesis AR700 SERIES Software Release 2.7.1 Manual de usuario Pagina 95

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 118
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 94
95
Software Release 2.7.1
C613-02047-00 REV A
2. Configure Frame Relay.
To configure a Frame Relay interface over a synchronous port to Router D,
and add a data link circuit to the Frame Relay interface, enter the
commands:
create framerelay=0 over=syn0 lmischeme=none
add framerelay=0 dlc=20
3. Configure ISDN.
Set up an ISDN call to Router A for DVMRP multicast traffic. This call
must have the same name as the ISDN call from Router A, and the opposite
precedence. Enter the command:
add isdn call=dvmrp outsub=local searchsub=local
precedence=in num=7654321
4. Configure PPP.
To configure a PPP interface over the ISDN interface, enter the command:
create ppp=0 over=isdn-dvmrp idle=on
5. Configure IP.
To enable the IP module, and assign IP addresses to the interfaces, enter the
commands:
enable ip
add ip interface=fr0 ipaddress=202.96.152.12
mask=255.255.255.0
add ip interface=ppp0 ipaddress=203.45.90.3
mask=255.255.255.0
add ip interface=eth0 ipaddress=172.74.2.3
mask=255.255.255.0
6. Configure IGMP.
To enable IGMP on the router and on the interfaces over which group
membership is to be managed, enter the commands:
enable ip igmp
enable ip igmp interface=eth0
enable ip igmp interface=ppp0
enable ip igmp interface=fr0
7. Configure DVMRP.
Enable DVMRP on the router, and assign the interfaces over which
DVMRP will perform multicast routing. Enter the commands:
enable dvmrp
add dvmrp interface=eth0 metric=1
add dvmrp interface=ppp0 metric=3
add dvmrp interface=fr0 dlc=20 metric=6
Vista de pagina 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 117 118

Comentarios a estos manuales

Sin comentarios