Allied-telesis ALLIEDVIEW-UM 1.6 Manual de usuario Pagina 70

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 129
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 69
Allied Telesis AlliedView-UM 1.6
User's Guide
PN 613-000381 Rev B
Page 70 of 129
Upload Parameters
1. Server - This is the address for the server that contains the Configuration file. If the server is a TFTP
server, the server address should be specified as an IP address. If the server is an HTTP server, the
server address should be specified as a URL.
2. Destination - This sets the location where the new Configuration file will be stored. This can be set to
FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.
NOTE:
The Destination field is not applicable to devices that use non-AlliedWare™ management software and will be ignored during
the Configuration File Update operation.
Since devices that use non-AlliedWare™ management software only support TFTP, the Protocol field will also be ignored but
will internally be set to "TFTP" during the Configuration File Update operation.
Vista de pagina 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 128 129

Comentarios a estos manuales

Sin comentarios