
Chapter 2: Installation
52
Powering on the switch
To power on the AT-x230-10GP or AT-x230-18GP switch, perform the
following procedure:
1. Lift the power cable hook, as shown in Figure 23, on the back of the
switch.
FIGURE 23. LIFTING THE AC POWER CABLE HOOK ON AN X230 SERIES
S
WITCH
Power cable hook
Power cable hook mount
2. Plug the power cord into the AC power connector, as shown in
Figure 24, on the back of an AT-x230-10GP or AT-x230-18GP switch.
F
IGURE 24. PLUGGING IN THE AC POWER CORD ON AN X230 SERIES SWITCH
Comentarios a estos manuales