
Chapter 8: Installing the Transceivers and Cabling the Ports
168
Figure 111. Removing the Dust Cover from an SFP or SFP+ Transceiver
in the AT-SBx31CFC960 Controller Fabric Card
The dust cover protects the fiber optic port on the transceiver from
dust contamination. It should not be removed until you are ready to
connect the fiber optic cable.
5. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 112. The connector should snap into the port.
Figure 112. Attaching a Fiber Optic Cable to an SFP or SFP+ Transceiver
in the AT-SBx31CFC960 Controller Fabric Card
Comentarios a estos manuales