Allied-telesis AT-SBx3106WMB Manual de usuario descargar pdf (Pagina 32)

Installation Instructions

Installing the Brackets on the Chassis

This procedure installs the wall brackets on the chassis.

Note

Do not remove the shipping brace from the front of the chassis until

after the unit is installed on the wall. You might bend the chassis and

cause misalignment of the slots and card guides if you lift the

chassis without the shipping brace. You should reinstall the shipping

brace if you have already removed it. Refer to Figure 13.

Caution

If the chassis already contains line cards and power supplies, you

should remove them and reinstall the shipping brace before

installing the chassis on the wall.

Figure 13. Shipping Brace

To install the brackets on the chassis, perform the following procedure:

1. With a #2 Phillips-head screwdriver, remove the two pre-installed rack

mount brackets from the sides of the chassis. Refer to Figure 14 on

page 33.

Shipping Brace

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Sin comentarios

Allied-telesis AT-SBx3106WMB Manual de usuario Pagina 32