Allied-telesis AT-S31 Manual de usuario descargar pdf (Pagina 41)

AT-S31 Version 1.0.1 User’s Guide

'LVDEOLQJRU(QDEOLQJD/LQN7HVW

A link test is a fast and easy way for you to test the connections between

the media converter ports and the end-nodes that are connected to the

ports. If a network problem occurs, you can perform a link test to

determine which port is experiencing the problem and so be able to

focus your troubleshooting efforts on the cable and end-node where the

problem resides.

To enable or disable a link test, perform the following procedure:

1. From the Main Menu, select Module status and configuration.

The Chassis Status Menu is displayed.

2. Use the arrow keys on the keyboard to highlight a module on which

you want to enable or disable a link test.

3. Press <Return>.

Note

Performing a link test does not interfere with a media converter’s

ability to pass network traffic, except for the AT-PB1000 Series

modules.

An example of the Module Configuration Menu is shown below:

4. Adjust the setting as required. Changes are immediately activated.

5. Return to the Main Menu.

Module Configuration Menu

Module 1 - AT-PB13

Module: AT-PB13

Type & Version: 01h

Power: On

Port Link Speed Mode RX/ACT

A(10BaseFL) Online 10M Full On

B(10BaseT) Online 10M Full On

Module name AT-PB13

Enable link test (MissingLink is off)

> Disable link test (MissingLink is on)

Return to Chassis Status Menu...

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Sin comentarios

Allied-telesis AT-S31 Manual de usuario Pagina 41