Allied-telesis AT-S25 Manual de usuario descargar pdf (Pagina 114)

Section II: Local and Telnet Mangement

114

Displaying Port’s RSTP Status and Settings

Unlike the information displayed for STP, the RSTP status and settings

information are listed separated in the AT-S25 software, under the

following menus:

❑ Display RSTP Port Settings

❑ Display RSTP Port State

Displaying a

Port’s RSTP

Settings

To display a port’s RSTP settings, perform the following procedure:

1. From the Spanning Tree Menu, type 2 to select Active Protocol Version.

The following prompt is displayed:

Enter new value (S-STP, R-RSTP):

2. Type R to select RSTP.

3. Type 4 to select RSTP Configuration.

The RSTP Menu in Figure 40 on page 110 is displayed.

4. From the RSTP Menu, type P to select RSTP Port Parameters.

The RSTP Port Parameters window in Figure 37 on page 107 is

displayed.

5. From the RSTP Port Parameters window, type M if you wish to select

a module other than the one currently displayed.

The prompt message is displayed:

Select Module ID: [1 to 8] ->

6. Enter the ID of the module you wish to select, and press the Enter key.

7. In the RSTP Port Parameters window, type 2 to select Display RSTP Port

Settings.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 275 276

Sin comentarios

Allied-telesis AT-S25 Manual de usuario Pagina 114