Allied-telesis AT-S101 Manual de usuario descargar pdf (Pagina 65)

AT-S101 Management Software User’s Guide

Mapping CoS Priorities to Egress Queues

This procedure explains how to change the default mappings of CoS

priorities to egress priority queues, as shown in Table 1 on page 63. This

is set at the switch level. You cannot set these mappings on a per-port

level. You can also use this procedure to enable and disable QoS on the

switch.

To change the default mappings of CoS priorities to egress priority queues

or to enable or disable the QoS feature, perform the following procedure:

1. From the menu on the left side of the page, select Bridge.

The Bridge folder expands to show the VLAN folder.

2. From the VLAN folder, select CoS.

The CoS Page is shown in Figure 21.

Figure 21. CoS Page

3. To enable or disable QoS, select Enable or Disable from the QoS

Status pull-down menu. The default is Disable.

4. To change the egress priority queue assignment of an 802.1p priority

class, click the dialog circle of the queue for the corresponding priority.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 237 238

Sin comentarios

Allied-telesis AT-S101 Manual de usuario Pagina 65