Allied-telesis AT-MC605 Manual de usuario descargar pdf (Pagina 32)

Overview

Selecting a Site for the AT-MC605 Ethernet Extender

Observe the following requirements when choosing a site for your

AT-MC605 VDSL Ethernet Extender:

 If you plan to install a AT-MC605 Ethernet Extender into an AT-

MCR12 rackmount chassis and equipment rack, check to be sure that

the rack is safely secured and that it will not tip over. Devices in a rack

should be installed starting at the bottom, with the heavier devices

near the bottom of the rack.

 The AT-MC605 Ethernet Extender may be wall mounted either on a

DINRAIL using a DINRAIL bracket or using an AT-WLMT bracket.

Both brackets are provide separately. Select a place on the wall that

provides the best cabling and power access.

Note

Both the DINRAIL bracket and the AT-WLMT wall mount bracket are

sold separately. Contact your Allied Telesis Sales representative to

purchase these items.

 If you are installing the AT-MC605 Ethernet Extender on a table, be

sure that the table is level and secure.

 The power outlet for the AT-MC605 Ethernet Extender should be

located near the unit and should be easily accessible.

 The site should provide for easy access to the ports on the front of the

AT-MC605 Ethernet Extender. This makes it easy for you to connect

and disconnect cables, as well as view the LEDs.

 To allow proper cooling of the AT-MC605 Ethernet Extender, air flow

around the unit and through its vents on the side should not be

restricted.

 Do not place objects on top of the AT-MC605 Ethernet Extender.

 Do not expose the AT-MC605 Ethernet Extender to moisture or water.

 Make sure that the site is a dust-free environment.

 You should use dedicated power circuits or power conditioners to

supply reliable electrical power to the AT-MC605 Ethernet Extender.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Sin comentarios

Allied-telesis AT-MC605 Manual de usuario Pagina 32