Allied-telesis AT-FS705LE Manual de usuario descargar pdf (Pagina 40)

Troubleshooting

If the LINK/ACT LED is OFF, do the following:

❑ Check to be sure that the end-node

connected to the port on the switch is

powered ON. If the end-node is OFF,

power the unit ON.

❑ Check that the cable is securely connected

to the port on the switch and on the end-

node.

❑ Check to be sure that the distance

between the switch and the end-node does

not exceed 100 meters (328 feet).

❑ Check to be sure that you are using

Category 5 cable.

❑ Check to be sure that the cable has not

been cut or damaged.

If there is a communication problem between

the end-nodes connected to the switch, do the

following:

❑ Verify that the switch and end-nodes are

operating with the same duplex mode.

If you are still experiencing problems after

testing and troubleshooting the installation,

refer to “Contacting Allied Telesyn” on page xi .

For support information, visit our web site at

www.alliedtelesyn.com.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Sin comentarios

Allied-telesis AT-FS705LE Manual de usuario Pagina 40