Allied-telesis AT-DC2552XS Manual de usuario descargar pdf (Pagina 46)

Chapter 3: Installing the Switch and Modules

This procedure requires the following items:

 Eight bracket screws (included with the switch)

 Two equipment rack brackets (included with the switch)

 Cross-head screwdriver (not provided)

 Four standard equipment rack screws (not provided)

Perform this procedure to install the switch in a 19-inch equipment rack:

Note

If you have installed the rubber feet, remove the rubber feet by

prying them off the bottom of the chassis with a flat-bladed tool.

1. Secure the two rack mount brackets to the sides of the switch using

the eight bracket screws provided. Figure 16 shows an example of

mounting the rack mount bracket on the front of the chassis and with

the bracket flush to the front panel. See Figure 15 for other possible

bracket mounting positions on the chassis.

Figure 16. Attaching the Brackets to Switch

Caution

The chassis may be heavy and awkward to lift. Allied Telesis

recommends that you get assistance when mounting the chassis in

an equipment rack.  E28

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 83 84

Sin comentarios

Allied-telesis AT-DC2552XS Manual de usuario Pagina 46