Allied-telesis AT-CV5001 Manual de usuario Pagina 69

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 86
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 68
AT-CV5001 Media Converter Chassis Installation Guide
69
Removing or Replacing the AT-CV5001AC Power Supply
The AT-CV5001AC Power Supply is hot-swappable. You do not have to
power off the chassis to install a second power supply or to replace a
failed power supply in a chassis that has two power supplies.
There are two power supply slots. This procedure illustrates slot A. The
procedure is the same for slot B.
Note
The predecessor to the AT-CV5001 Chassis, the AT-CV5000
Chassis, had different power supply modules for the left and right
slots. This is not the case for the AT-CV5001AC Power Supply,
which can be installed in either power supply slot in the AT-CV5001
Chassis.
To remove or replace the AT-CV5001AC Power Supply, perform the
following procedure.
1. Disconnect the power cord from the power source.
2. Disconnect the power cord from the AT-CV5001AC Power Supply.
Figure 35. Removing the Power Cord from the AT-CV5001AC Power
Supply
A
A
T-CV5001
AC
DISCONNECT ALL
PO
WER SUPPLIES &
REFER
T
O MAN
U
AL BEFORE SE
RVICING
.
100-240VAC~
A
W
A
R
N
IN
G
This unit
might h
a
ve more than one p
o
wer input
.
T
o reduce
t
of electric shoc
k, disconnect all po
wer inputs before ser
vicin
o
1671
Vista de pagina 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 85 86

Comentarios a estos manuales

Sin comentarios