
Chapter 2: Installation
32
Powering On the Chassis
Note
Use only power sources that are UL Listed (QQGQ or EPBU), TUV
Licensed or other Safety Agencies approved, and that are suitable
for country of use.
To power on the AT-CV1203 Chassis, perform the following procedure:
1. Connect the power cord to the power adapter, as shown in Figure 14.
Figure 14. Connecting the Power Adapter and Power Cord
2. Plug the DC connector on the power adapter to either the PWR A or
PWR B connector on the back panel of the chassis.
1577
Comentarios a estos manuales