Allied Telesis AT-8100S/24C Guía de usuario descargar pdf (Pagina 312)

Chapter 25: LLDP and LLDP-MED

312

Setting a Location Entry for the LLDP-MED Location TLV

You can define location information about a network device as a LLDP-

MED TLV and include the TLV in an LLDPDU, which the switch sends to

its neighbors. Unlike some of the other LLDP-MED LLDP TLVs, such as

capabilities and network policy TLVs, which have pre-set values, a

location TLV must be specified before a port sends it to the neighbors.

To include location information in LLDPDUs, you must create a location

entry with the relevant location information, apply it to one or more ports

on the switch, and then specify a port to include the location TLV-MED in

LLDPDUs.

The procedures in this section allow you to create LLDP-MED Civic,

Coordinate, and ELIN location entries. See the following:

 “Creating a Civic Location Entry” on page 312

 “Creating a Coordinate Location” on page 316

 “Creating an Emergency Location Identification Number (ELIN)

Location” on page 319

Note

To apply a location entry to a port, see “Assigning LLDP Locations to

a Port” on page 322. To specify a port to include a location LLPD-

MED TLVs, see “Selecting LLDP-MED TLVs on a Port” on

page 324.

Creating a Civic

Location Entry

To create an the LLDP Civic Location, do the following:

1. Select the Discovery & Monitoring tab.

The Discovery & Monitoring tab is displayed. See Figure 123 on

page 302.

2. From the Discovery & Monitoring tab, select LLDP.

The LLDP tab appears on the right.

3. From the LLDP tab, select Locations.

The Locations tab is displayed. See Figure 130 on page 313.

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 349 350

Sin comentarios

Allied Telesis AT-8100S/24C Guía de usuario Pagina 312