Allied Telesis L2TP Tunnel Manual de usuario

Busca en linea o descarga Manual de usuario para Routers Allied Telesis L2TP Tunnel. Allied Telesis L2TP Tunnel User's Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 6
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
C613-16037-00 REV C
www.alliedtelesis.com
AlliedWare™ OS
How To |
Introduction
This How To Note shows an example of using a dynamic routing protocol over an L2TP
tunnel.
Running dynamic routing protocols over a secure Internet connection can be a complex
issue, with the possibility of intermittent connections causing routing problems.
OSPF (or BGP) are more connection-oriented than RIP and therefore are more susceptible
to problems caused by intermittent loss of connection between 'neighbours'. A neighbour
that may bounce up and down can cause havoc to the correct propagation of OSPF routing
information for a network.
The following example scenario is for setting up RIP over an L2TP tunnel. RIP is simpler and
has less overhead and control, so it provides a more robust setup as a dynamic routing
protocol over an L2TP tunnel.
Which products does it apply to?
This Note applies to the following Allied Telesis routers, running software version 2.6.1 or
later:
z AR400 series
z AR700 series
Configure Dynamic Routing Over An L2TP Tunnel
Vista de pagina 0
1 2 3 4 5 6

Indice de contenidos

Pagina 1 - How To

C613-16037-00 REV Cwww.alliedtelesis.comAlliedWare™ OSHow To |IntroductionThis How To Note shows an example of using a dynamic routing protocol over a

Pagina 2 - Related How To Notes

Page 2 | AlliedWare™ OS How To Note: Dynamic Routing over L2TPAn example scenario for RIP over L2TPRelated How To NotesYou may also find the following

Pagina 3 - Routing Information

Page 3 | AlliedWare™ OS How To Note: Dynamic Routing over L2TPAn example scenario for RIP over L2TPNetwork OperationThere is a single static route con

Pagina 4 - Routing Considerations

Page 4 | AlliedWare™ OS How To Note: Dynamic Routing over L2TPAn example scenario for RIP over L2TPRouting ConsiderationsA routing issue to consider i

Pagina 5 - Configurations

Page 5 | AlliedWare™ OS How To Note: Dynamic Routing over L2TPConfigurationsConfigurationsCentral Office Routerset system name=Central_Officeenable l2

Pagina 6 - Remote Office Router

USA Headquar ters | 19800 Nor th Cr eek Parkwa y | Suite 100 | Bothell | WA 98011 | USA | T: +1 800 424 4284 | F: +1 425 481 3895

Comentarios a estos manuales

Sin comentarios