
Features in 276-02 20
Version 276-03
C613-10474-00 REV B
CR00012040
IP Gateway,
WAN load
balancer
3 If policy-based routing and the WAN load balancer were both configured, the
load balancer balanced traffic even if it matched the routing filter. Because the
purpose of policy-based routing is to control the route that traffic uses, this was
incorrect.
This issue has been resolved. Traffic that matches a policy-based routing filter
now bypasses the WAN load balancer.
YYY- ------
CR00012175
OSPF 3 In a segmented NBMA network, in which more than one designated router was
elected for the network, sometimes the router or switch did not add the routes
to the extra designated routers. Note that a segmented network like this only
occurs as the result of an incorrect configuration.
This issue has been resolved. The router or switch correctly determines routes in
such a network.
YYYYYYYYYY
CR00012265
ATM 3 Previously, ATM interfaces stopped transmitting when any of the following
happened:
■ the command reset pri was entered
■ the command reset bri was entered
■ more than two ISDN calls were opened (on Software Versions prior to 2.7.6)
This issue has been resolved.
Y---------
CR00012283
Switch 3 Previously, it was not possible to create two protocol-based VLANs on the same
ports if they had the same protocol but a different Ethernet encapsulation.
This issue has been resolved, so you can now create such VLANs.
-------YY-
CR00012305
QoS 3 When a user entered a maxbandwidth for QoS, the switch sometimes displayed
a message that said the bandwidth units were “kbytes” instead of kilobits per
second.
This issue has been resolved.
---YYYY- - -
CR Module Level Description
AR44x / AR450
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800
Comentarios a estos manuales