Allied Telesis AT-2931SX Guía de instalación descargar pdf (Pagina 114)

Chapter 10: Troubleshooting

114

NetWare To ping an IP host on the network to verify a connection has been

established, perform the following procedure.

1. From the command line, type ping <IP address>, then press Enter.

This command displays the packet send/receive status.

Linux To verify that the Ethernet interface is up and running, run ifconfig to

check the status of the Ethernet interface. In addition, you can also use

the netstat -i command to check the statistics on the Ethernet

interface. Consult the manual pages for more information about the

ifconfig and netstat commands.

To ping an IP host on the network to verify connection has been

established, perform the following procedure.

1. From the command line, type ping <IP address>. Then press Enter.

This command displays the packet send/receive status.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 139 140

Sin comentarios

Allied Telesis AT-2931SX Guía de instalación Pagina 114