Allied-telesis AlliedWare NetScreen Routers Manual de usuario descargar pdf (Pagina 7)

Use Dynamic DNS To Allow You To Host Servers Behind A Dynamically-Assigned Public IP Address 7

Configure dynamic DNS

This section describes how to configure dynamic DNS.

Use the command:

enable ddns

Depending on the kind of DynDNS.com host you have (see “DynDNS.com hostnames” on

page 2), use one of the commands:

set ddns dynamichost=your-hostname.dyndns-domain

set ddns statichost=your-hostname.dyndns-domain

set ddns customhost=your-hostname.your-domain

Note that the dynamic DNS client only supports one type of hostname at a time, but

supports multiple hostnames of that type. If you have multiple hostnames, specify them as a

comma-separated list. For example:

set ddns dynamichost=myhost1.dyndns.org,myhost2.dnsalias.org

Specify the interface that the WAN link uses.

For the primary ADSL link, use the command:

set ddns primaryinterface=ppp0

If you also have the backup ISDN link, also use the command:

set ddns secondaryinterface=ppp1

Note that the dynamic DNS client only supports one active WAN interface at a time.

1. Enable dynamic DNS

2. Specify the DynDNS.com host or hosts

3. Specify the dynamic DNS interface

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Allied-telesis AlliedWare NetScreen Routers Manual de usuario Pagina 7