Allied-telesis SwitchBlade Chassis and Fan Tray Manual de usuario descargar pdf (Pagina 6)

6 SwitchBlade Chassis and Fan Tray

C613-04029-01 REV C

Figure1: SwitchBlade rack crossbar.

5. Remove any packaging and protective material

Inside the chassis: Check that the internal spaces are free of packaging and

protective material.

Outside the chassis: Check that all vents are free from obstruction.

6. Insert the blank faceplates (if not factory fitted)

When inserting a faceplate, make sure the faceplate’s metal back-panel is

aligned with the card guides (see Figure 2 on page -6).

Faceplates are mounted vertically in the SwitchBlade 8 chassis (AT-SB4108) and

horizontally in the SwitchBlade 4 chassis (AT-SB4104).

Figure2: Card guides.

Carefully slide the faceplate into the chassis. The faceplate’s captive screws

should line up with the threaded holes on the chassis.

SwitchBlade Support Bar

bottom card guide

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Allied-telesis SwitchBlade Chassis and Fan Tray Manual de usuario Pagina 6