Allied-telesis OmniConnect ISDN Manual de usuario descargar pdf (Pagina 19)

OmniConnect ISDN Quick Install Guide

Plug the AC power adapter provided with the unit into the correct AC power

source for this adapter. Next connect the DC cable from the adapter into the

OmniConnect DC input.

Verify that the Power LED lights (see LED table).

5. Verify that the Ethernet LEDs light green (see LED table).

For troubleshooting techniques, refer to your Installation Guide.

You are now ready to configure and setup the OmniConnect. To continue, see

“Verify your PC Configuration” on page 10.

LED Color State Description

Power Green On The unit is receiving power, voltage is within the acceptable

range, and the power supply is working.

Off No power.

Col Amber Flashing The unit is experiencing collisions on the LAN segment. It is

normal for this indicator to flash on occasion

Off Normal operation.

Ethernet Green On The port is connected to a active 10Base-T repeater or

adapter and the link is active.

Flashing The port is receiving data packets.

Off Port is not connected to an active 10Base-T repeater or

adapter.

ISDN Activ-

ity:

B1, B2, D

Green or

Amber

On The channel is connected to an active ISDN switch.

Flashing The channel is receiving and transmitting.

Off The channel is not active.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Sin comentarios

Allied-telesis OmniConnect ISDN Manual de usuario Pagina 19