Allied-telesis AT-S94 Manual de usuario descargar pdf (Pagina 181)

Configuring LLDP

Page 181

Defining Global LLDP Properties

The LLDP Properties Page allows network managers to assign global LLDP parameters.

To enable and configure LLDP on the device:

1. Click LLDP > Properties. The LLDP Properties Page opens:

Figure 125:LLDP Properties Page

The LLDP Properties Page contains fields for configuring LLDP:

• Enable LLDP — Indicates if LLDP is enabled on the device. The possible field values are:

– Checked —Enables LLDP on the device. This is the default value.

– Unchecked — Disables LLDP on the device.

• Updates Interval (5 - 32768) — Indicates the interval (sec) between consecutive LLDP advertisement

updates The possible field range is 5 - 32768 seconds. The default value is 30 seconds.

– Use Default — Selecting the check box returns settings to default.

• Hold Multiplier (2 - 10) — Indicates the amount of time that LLDP packets are held by a receiving device

before the packets are discarded. The value represents a multiple of the Updates Interval. The possible field

range is 2 - 10. The field default is 4. For example, if the Update Interval is 30 seconds and the Hold Multiplier

is 4, then the LLDP packets are discarded after 120 seconds.

– Use Default — Selecting the check box returns settings to default.

• Reinitializing Delay (1 - 10) — Indicates the amount of time an LLDP port waits before reinitializing LLDP

transmissions. The possible field range is 1 - 10 seconds. The default value is 2 seconds.

– Use Default — Selecting the check box returns settings to default.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 249 250

Sin comentarios

Allied-telesis AT-S94 Manual de usuario Pagina 181