Allied-telesis AT-S63 Manual de usuario descargar pdf (Pagina 484)

100

101

Chapter 27: Rapid Spanning Tree Protocols Commands

484 Section V: Spanning Tree Protocols

portpriority Specifies the port’s priority. This parameter is used as a

tie breaker when two or more ports are determined to

have equal costs to the root bridge. The range is 0 to

240 in increments of 16, for a total of 16 increments, as

shown in Table 19. You specify the increment that

corresponds to the desired value. The default is 128,

which is increment 8.

edgeport Defines whether the port is functioning as an edge port.

An edge port is connected to a device operating at half-

duplex mode and is not connected to any device

running STP or RSTP. The options are:

yes, on, true The port is an edge port. The options

are equivalent. This is the default.

no, off, false The port is not an edge port. The

options are equivalent.

ptp or Defines whether the port is functioning as a point-

pointtopoint to-point port. The parameters are equivalent. This type

of port is connected to a device operating at full-duplex

mode. The options are:

100 Mbps 20,000

1000 Mbps 2,000

Table 19. Port Priority Value Increments

Increment

Bridge

Priority

Increment

Bridge

Priority

008128

1169144

2 3210160

34811176

4 6412192

5 8013208

6 9614224

7 112 15 240

Table 18. RSTP Auto-Detect Port Trunk Costs

Port Speed Port Cost

1 2 ... 479 480 481 482 483 484 485 486 487 488 489 ... 679 680

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-S63 Manual de usuario Pagina 484

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-S63