Allied-telesis AT-S41 Manual de usuario descargar pdf (Pagina 189)

AT-S41 User’s Guide

189

If the switch does not contain a port trunk, all of the ports on the

switch will be un-checked. If there is a port trunk, the ports of the

trunk will be checked.

2. To create a port trunk, do the following:

a. Check the ports that will make up the port trunk. A port trunk can

contain up to four ports. All of the ports in a port trunk must be in

the same trunk group.

b. Select Enable from the pull-down menu to the right of the trunk

group that contains the port trunk members.

c. Click the Apply button to the right of the port trunk group you

enabled.

The new port trunk is immediately activated on the switch.You

can now connect the data cables to the ports of the trunk on the

switch.

3. To delete a port trunk do the following:

a. Deselect all port members of the trunk you want to delete.

b. Select Disable from the pull-down menu to the right of the trunk

group that contained the port trunk members.

c. Click the Apply button to the right of the port trunk group you

disabled.

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 232 233

Sin comentarios

Allied-telesis AT-S41 Manual de usuario Pagina 189