
Chapter 2: Installation
40
Powering On the Chassis
To apply power to the AT-MCF2000AC power supply
module and the AT-MCF2000 chassis, perform the
following procedure:
1. Verify that the power switch on the module is set to
OFF.
2. Plug the appropriate power cord for your region or
country into the AC power connector on the back panel
of the unit and plug the other end into an appropriate
power source. Refer to “Power Specifications” on
page 48 or the AT-MCF2000AC Power Supply Module
Installation Guide for the power requirements of the
chassis and the power module.
Figure 18. Connecting the AC Power Cord
1116-a
A
T
-MC
F
2
K
PN
L
3
NORMAL
FAU
LT
STATU
S
PSU
FAN
M
A
Comentarios a estos manuales