Allied-telesis AT-MCF12VF, SM Manual de usuario descargar pdf (Pagina 27)

AT-MCF6xx and AT-MCF12xx Installation Guide

Installing the Media Converter in a Rack

To install the unit in a 19-inch rack, perform the following steps:

1. Remove all equipment from the shipping package and store the package

in a safe place.

Caution

Do not remove the dust covers from the fiber optic ports on the media

converter until you are ready to connect the cables. Dust contamination

can adversely impact the operation of the fiber optic ports.

2. Select a level, secure surface to prepare the media converter.

3. If you purchased an optional redundant power supply for the switch,

install the redundant power supply by following the directions included

with the unit.

Note

Do not remove the back panel covering the expansion slot for the

optional redundant power supply unless you intend to install the unit.

4. Place the mounting bracket over the mounting holes on one side of the

unit. Insert the three screws provided with the unit and tighten with a

suitable screwdriver, as shown in Figure 8.

Figure 8 Installing the Mounting Bracket

5. Repeat Step 4 to install the remaining bracket on the other side of the

unit.

6. Insert the unit into a 19-inch rack and secure with suitable screws (not

provided).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Sin comentarios

Allied-telesis AT-MCF12VF, SM Manual de usuario Pagina 27