Allied-telesis AT-GS900/24 Manual de usuario descargar pdf (Pagina 35)

AT-GS900/16, AT-GS900/24 Fanless Gigabit Ethernet Switches Installation Guide

Cabling the Switch

To connect to the ports on the AT-GS900/16 and AT-GS900/24 switches,

perform the following procedure:

1. Connect the twisted pair data cables to the RJ-45 ports on the switch,

as illustrated in Figure 12.

Figure 12. Connecting the Twisted Pair Data Cables

2. Power on the end-nodes. For more information, refer to “Powering On

the Switch” on page 36.

When connecting a twisted pair cable to a port, observe the following

guidelines:

 An RJ-45 connector should fit snugly into the port on the switch.

The tab on the connector should lock the connector into place.

 The ports on the switch are auto-MDI/MDI-X. You can use either a

straight-through or crossover twisted pair cable to connect any type

of network device to a port on the switch.

 The network should not contain data loops, which can adversely

affect network performance. A data loop exists when two or more

network devices can communicate with each other over more than

one data path.

613

1 2 ... 30 31 32 33 34 35 36 37 38 39 40

Sin comentarios

Allied-telesis AT-GS900/24 Manual de usuario Pagina 35