Allied-telesis AT-FS717FC/xx Manual de usuario descargar pdf (Pagina 16)

Fiber Optic Port

The AT-FS713FC/xx and AT-FS717FC/xx Series Switches have one

100Base-FX fiber optic port. The fiber optic port has a FJ, LC, MT, SC, ST, or

VF connector, depending on the model.

Port Speed

The fiber optic port is compliant with the 100Base-FX standard and has a

fixed operating speed of 100 Mbps. The end-node connected to the fiber optic

port on the switch must also be able to operate at 100 Mbps.

Duplex Mode

Duplex mode refers to the way an end-node sends and receives data on the

network. An end-node can operate in either half- or full-duplex mode,

depending on its capabilities. An end-node that is operating in half-duplex

mode can either send data or receive data, but it cannot do both at the same

time. An end-node that is operating in full-duplex mode can send and receive

data simultaneously. The best network performance is achieved when an end-

node can operate at full-duplex, since the end-node is able to send and receive

data simultaneously.

The AT-FS713FC/xx and AT-FS717FC/xx Series Switches can operate in

either half- or full-duplex mode. To set the duplex mode on the fiber optic port,

slide the 100FX DUPLEX switch UP (half-duplex) or DOWN (full-duplex). The

switch can operate with end-nodes capable of either half-duplex mode or full-

duplex mode.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

Sin comentarios

Allied-telesis AT-FS717FC/xx Manual de usuario Pagina 16