Allied-telesis AT-9448Ts/XP Manual de usuario descargar pdf (Pagina 49)

AT-9400 Stack Installation Guide

Installing the Switches in an Equipment Rack

Note

Installing a stack on a table or desktop is not recommended because

it may create a hazardous work area.

Perform the following procedure to install each switch in a standard

19-inch rack:

Note

Steps 1, 2, and 3 are optional. They remove the snap-on plastic feet

from the bottom of a switch. The feet can be left on.

1. Place the switch upside down on a level, secure surface.

2. Using a flat-head screwdriver, remove the snap-on plastic feet from the

bottom of the switch, as shown in Figure 14.

Figure 14. Removing the Feet

3. Turn the switch over.

4. Attach a rack-mount bracket to one side of the switch using four of the

screws that come with the switch, as shown in Figure 15.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 99 100

Sin comentarios

Allied-telesis AT-9448Ts/XP Manual de usuario Pagina 49