Allied-telesis AT-S88 Manual de usuario descargar pdf (Pagina 96)

Chapter 9: Class of Service (CoS)

Mapping CoS Priorities to Egress Queues

This procedure explains how to change the default mappings of CoS

priorities to egress priority queues, shown in Table 3 on page 85. This is

set at the switch level. You cannot set this at the per-port level.

To change the CoS priority mappings, perform the following procedure.

1. From the main menu, select Bridge > CoS.

The CoS page is shown in Figure 29.

Figure 29. CoS Page

2. For each priority whose queue you want to change, select a queue in

the CoS Queue list.

3. Do one of the following:

 Click OK to save the changes.

 Click Reload to clear the changes and start over.

4. To permanently save these settings in the configuration file, from the

main menu, select Save Configuration.

The Save Configuration page is shown in Figure 3 on page 13.

5. Click Save.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 157 158

Sin comentarios

Allied-telesis AT-S88 Manual de usuario Pagina 96