
Chapter 30: Simple Network Management Protocol (SNMP)
298 Section II: Using the Web Browser Interface
Deleting Traps
Use this procedure to delete traps for an SNMP community.
To delete a trap, perform the following procedure:
1. From the bookmarks on the left side of the page, select Bridge.
2. From the Bridge folder, select SNMP.
3. From the SNMP folder, select Trap Setting.
The Trap Setting page is shown in Figure 86 on page 296.
4. In the Trap table, click delete
next to the trap you want to delete from
the table.
The Trap Setting page is updated.
Comentarios a estos manuales