Allied-telesis AT-RPS1000 Manual de usuario descargar pdf (Pagina 4)

AT-RPS1000 Installation

Redundant Power Supply Front View

Figure 1 shows the front panel view of the AT-RPS1000.

Figure 1:

Redundant Power Supply Front Panel

LEDs

Table 1 describes the LED behavior on the AT-RPS1000.

NOTE

If the AT-RPS1000 DC cables are not connected to a gigabit switch, but

the AC power cords are connected to an AC outlet, the RPS1 and RPS2

LEDs will blink. If one of the cables is properly connected to a gigabit

switch, but the remaining cable is not, the unconnected cable will cause

its associated AT-RPS1000 LED to blink.

Table 1:

AT-RPS1000 LEDs

LED Color Indicates

RPS 1 Green The first redundant power supply is powering a gigabit switch.

RPS2 Green The second redundancy power supply is powering a gigabit

switch.

OVER

TEMP

Off

Yellow

The AT-RPS1000 temperature is normal.

The AT-RPS1000 is indicating an overheat condition (>60

degrees Celsius).

FAN FAIL Off

Ye ll o w

The AT-RPS1000 fan is operating properly.

The AT-RPS1000 fan speed has slowed to 80 percent or less of

full rotational speed and should be replaced.

1 2 3 4 5 6 7 8 9

Sin comentarios

Allied-telesis AT-RPS1000 Manual de usuario Pagina 4