Allied-telesis AT-GS924 Manual de usuario Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 50
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
AT-GS916 and AT-GS924 Gigabit Ethernet Switches Installation Guide
29
Cabling the Switch
To connect to the ports on the AT-GS916 and AT-GS924 switches,
perform the following procedure:
1. Connect the twisted pair data cables to the RJ-45 ports on the switch,
as illustrated in Figure 13.
Figure 13 Connecting the Twisted Pair Data Cables
2. Power on the end-nodes. For more information, refer to ”Powering
On the Switch” on page 30.
When connecting a twisted pair cable to a port, observe the
following guidelines:
An RJ-45 connector should fit snugly into the port on the switch.
The tab on the connector should lock the connector into place.
The ports on the switch are auto-MDI/MDI-X. You can use either a
straight-through or crossover twisted pair cable to connect any
type of network device to a port on the switch.
The network should not contain data loops, which can adversely
affect network performance. A data loop exists when two or more
network devices can communicate with each other over more
than one data path.
1
3
5
7
2
4
6 8
13
14
15
16
10
ACT
FDX
100
1000
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 49 50

Comentarios a estos manuales

Sin comentarios