Allied-telesis AT-FS724i Manual de usuario descargar pdf (Pagina 23)

AT-FS716 Series and AT-FS724i Installation Guide

8. Check that the LINK/ACTIVITY LED for each port on the switch is green.

If a LED is OFF, refer to “Troubleshooting” on page 15.

The switch is now ready for use.

Rackmounting the Switch

The AT-FS716 and AT-FS724i switches can be used on a desktop or installed

in a rack. For desktop installation, refer to “Installing the Switch on a Table or

Desktop” on page 10.

To install the AT-FS716 or AT-FS724i in a rack, perform the following

procedure:

1. If attached, remove the four protective feet from the bottom of the switch as

shown in Figure 6.

Figure 6 Removing the Rubber Feet

2. Remove the data cables and power cord from the switch.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Sin comentarios

Allied-telesis AT-FS724i Manual de usuario Pagina 23