Allied-telesis AT-FS724L Manual de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 41
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
Chapter 2: Installation
36
Connecting the Ports and Powering On the Switch
To connect to the ports on the switch, perform the following procedure:
1. Connect the twisted-pair data cables to the RJ-45 ports on the switch,
as shown in Figure 14.
Figure 14. Connecting the Twisted-twisted-pairPair Data Cables
When connecting a twisted-pair cable to a port, observe the following
guidelines:
An RJ-45 connector should fit snugly into the port on the switch.
The tab on the connector should lock the connector into place.
The ports on the switch are auto-MDI/MDI-X. You can use either a
straight-through or crossover twisted-pair cable to connect any
type of network device to a port on the switch.
The network should not contain data loops, which can adversely
affect network performance. A data loop exists when two or more
network devices can communicate with each other over more than
one data path.
10 LINK
ACT
100 LINK
ACT
FDX HDX
COL
1
35791
11
3
1
5
246
810
12
14
16
1530
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41

Comentarios a estos manuales

Sin comentarios