Allied Telesis AT FS709FC AT-FS709FC AT-FS709FC Guía de instalación descargar pdf (Pagina 14)

Installation

6. Attach the data cables and observe normal operation as indicated by the port

LEDs. Use only one Port 8, either Port 8 MDI or Port 8 MDI-X. For typical

configuration information, refer to “Cascade Configuration” on page 9.

7. Attach fiber optic cable with SC connectors to Port 9 and observe LEDs for

normal operation.

Note

Auto-negotiation for transmission mode supports full-duplex only if the

connected device also negotiates for full-duplex transmission mode. Port 9

supports full-duplex operation only.

You are finished with rackmount installation.

Standalone Configuration

In a standalone configuration, the switch supports up to 9 network nodes. Figure 3 shows a

switch connected to end stations and a server. The basic physical connection for this

configuration requires connecting one of the switch’s ports to the adapter card of an end

station.

Figure 3

AT-FS709FC Connected to End Stations

TX RX

Copper

Fiber

Full-Duplex

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Sin comentarios

Allied Telesis AT FS709FC AT-FS709FC AT-FS709FC Guía de instalación Pagina 14