Allied Telesis Switch AT-S79 Manual de usuario descargar pdf (Pagina 210)

Chapter 20: Quality of Service (QoS)

210 Section II: Using the Web Browser Interface

Mapping CoS Priorities to Egress Queues

This procedure explains how to change the default mappings of CoS

priorities to egress priority queues, as shown in Table 2 on page 97. This

is set at the switch level. You cannot set this at the per-port level. This

procedure also enables and disables QoS.

To change the default mappings of CoS priorities to egress priority queues

or to enable or disable QoS, perform the following procedure:

1. From the Advanced Config menu, select QoS Config and then select

QoS Config.

The QoS Configuration page is shown in Figure 61.

Figure 61. QoS Configuration Page

2. To enable or disable QoS, select Enable or Disable from the QoS

Status pull-down menu. The default is disabled.

3. To change the egress priority queue assignment of an 802.1p priority

class, click the dialog circle of the queue for the corresponding priority.

For example, to direct all tagged traffic with a priority of 4 to egress

queue 3 on the ports, you would click the dialog circle for queue 3 in

the priority 4 row.

4. Click Apply.

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 241 242

Sin comentarios

Allied Telesis Switch AT-S79 Manual de usuario Pagina 210