Allied-telesis SwitchBlade Line Card Manual de usuario descargar pdf (Pagina 6)

6 SwitchBlade Line Card

C613-04030-01 REV H

The switch may overheat or be damaged by dust and debris if bays are left

uncovered.

To remove an existing line card:

Loosen the line card’s two Phillips screws until they disengage from the

chassis.

Move the line card ejector levers to the unlocked position (see Figure 2 on

page -6).

Slide the line card out of the chassis, keeping the card in a straight alignment

so it doesn’t jam.

Figure 2: Ejector levers.

6. Insert the new line card

Make sure the line card’s metal back-panel is aligned with the card guides

(see Figure 3 on page -7).

Line cards are mounted vertically in the SwitchBlade 8 (AT-SB4108) chassis and

horizontally in the SwitchBlade 4 (AT-SB4104) chassis.

With the ejector levers in the unlocked position (see Figure 2 on page -6),

carefully slide the line card into the chassis.

When inserting a line card, take care to slide the card’s metal back-panel along

both guides at an equal rate. If a line card becomes tight, it must not be forced.

Instead, gently withdraw the card and try again, taking extra care to keep the

card aligned with the card guides. Forcing a misaligned or jammed line card is

likely to damage the card or chassis.

The ejectors’ locking mechanisms should align with their slots in the

chassis (see Figure 4 on page -7).

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Allied-telesis SwitchBlade Line Card Manual de usuario Pagina 6